Users Guide ValueJet 1614
85 AP-75790 Rev 1.4 -22/02/2011,
4.7.17 Roll Length menu
Setup Item Setting Value Description
Roll media
<OFF>
Roll Length is not used.
[Enter] key: Save the setting and shift to the previous
hierarchy.
Roll1 Set up the roll media length.
The Roll Length setting can be set for "Roll1" to "Roll3".
[Enter] key: Save the setting and shift to the next hierarchy.
Refer to: Roll length menu
Roll2
Roll3
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
Refer to: Setup menu
4.7.17.1 Roll media Length menu
Setup Item Setting Value Description
Length
1m to <30m> to 99m
Set the roll media length.
Notes
When replacing the roll media, adjust the roll media length
again.
If the roll media length is not set, the residual quantity of
roll media will not be displayed correctly.
[Enter] key: Save the setting value and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
Refer to: Setup menu
4.7.18 Head Wash menu
Notes
Make sure to use a genuine cleaning fluid (model N°: RJ80U-22-CLN).
Setup Item Setting Value Description
Head Wash
Start
Perform head cleaning.
[Enter] key:
Perform the head cleaning operation.
The operation panel displays the following contents.
Remove
cassettes
Remove the ink cassette, and install the cleaning cassette.
Refer to: Replacing ink cassettes
[Cancel] key: Shift to the previous hierarchy without the head cleaning
operation.
Refer to: Setup menu
To Next Page
Loading...
Need help?
General