Users Guide ValueJet 1614
52 AP-75790 Rev 1.4 -22/02/2011,
4.3.3 Setting media type
Introduction:
Be sure to read and understand the safety warnings before handling the printer.
When you have loaded the media in the ValueJet, you will have to set the media type. The Media setup
menu is displayed after the media hold lever is pushed from the backward position to the forward position. (=
lever down)
Notes
The printer starts the media initialization without setting the media type when
The [Cancel] key of the operation panel is pressed.
No key operations are performed on the operation panel for 10 seconds.
Procedure:
Step 1 : Verify that the printer has been switched ON, and the media has been loaded.
Result: After the media is loaded, the display shifts to the Media setup menu.
Notes
Refer to the following topics to load media:
Installing roll media
Loading roll media
Step 2 : Press the [Setting value +] key or [Setting value-] key on the operation panel to select the correct
media type.
Step 3 : Press the [Enter] key on the operation panel to confirm your choice.
Result:
The media type is determined
The operation panel displays "Media Initial", and the media initialisation starts.
Step 4 : After media initialization, the operation panel displays "Ready to Print" and the printer shifts to
normal
Step 5 : When using the roll media, wind back the roll media to avoid slackness at the back.
Notes
The printer starts the media initialization without setting the media type when
The [Cancel] key of the operation panel is pressed.
No key operations are performed on the operation panel for 10 seconds.
To Next Page
Loading...
Need help?
General