Users Guide ValueJet 1614
96 AP-75790 Rev 1.4 -22/02/2011,
5.1 DONE BY END USER
This section describes the periodical services required for a ValueJet 1614 series printer. The periodical
services ensure stable printout quality of the machine. In the periodical services, some service parts need to
be checked, cleaned or replaced.
Important
Be sure to wear gloves when working with inks or cleaning liquid.
Perform periodical inspection according to the table below.
N° Action Frequency
1 Clean around the bottom of the head Weekly (or sooner if necessary)
2 Clean the wipers Weekly
3 Replace spitting box sponges 2 months
4 Clean media guide platen Several times a year
5 Clean timing fences Several times a year
6 Clean P-Rear sensor front surface Several times a year
7 Clean pressure rollers Several times a year.
Notes
Do not insert or drop metal or other objects through openings of the printer. It could lead to an electric
shock and / or fire.
When substances or liquids such as water entered the printer, do NOT use the printer. It could lead to
an electric shock and/or fire. Immediately
± Switch OFF the printer.
± Disconnect the power plugs from the electric sockets.
± Contact your local MUTOH dealer.
Notes
The accessory kit, delivered with the printer, contains items to perform the periodical
maintenance (except for cleaning liquid)
If running out of the necessary maintenance equipment, a user maintenance kit can be ordered.
This kit contains all items to perform the periodical maintenance.
Depending on the ink you are currently using, order the correct cleaning liquid.
5.1.1 Cleaning the printer
Periodic cleaning is necessary to use the printer in good condition.
To Next Page
Loading...
Need help?
General