Users Guide ValueJet 1614
74 AP-75790 Rev 1.4 -22/02/2011,
4.7.1.4 Init.Adj.Print menu
Setup Item Setting Value Description
Feed Length
100 mm to <250 mm> to 500 mm
Change the length (feed length) of the media feed
direction for the initial adjust print.
[Enter] key:
The setting value is determined.
"Printing" is displayed on the operation panel and the
initial adjust print is started.
After printing, the printer enters in the normal status.
[Cancel] key: Cancel the setting value and shift to
the previous hierarchy.
4.7.1.5 Init.Adj.Change menu
Setup Item Setting Value Description
Init.
200.0 mm to <250.0 mm> to
300.0 mm
Set up Initial Adjust Change.
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the
previous hierarchy.
4.7.1.6 Confirm Print menu
Setup Item Setting Value Description
Feed Length
100 mm to <250 mm> to 500 mm
Change the length (feed length) of the media feed
direction for the Confirm Print.
[Enter] key:
The setting is determined.
"Printing" is displayed on the operation panel and
initial adjust print is started.
After printing, the printer enters the normal status.
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the
previous hierarchy.
4.7.1.7 Micro Adj. Print menu
Setup Item Setting Value Description
Micro Adj. Print
Printing
Print the PF pattern (micro adjustment) with a focus
on the micro adjustment value.
Printing interval: ± 1 pulse
[Cancel] key: Shift to the previous hierarchy.
If the printer is terminated during printing it shifts to
the previous level.
4.7.1.8 Micro Adj.Change menu
Setup Item Setting Value Description
Micro Adj.Change
20 pulse to <0 pulse > to 20
pulse
Set up the Micro Adjustment Change.
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the
previous hierarchy.
Be sure to read and understand the safety warnings before handling the printer.
To Next Page
Loading...
