MUTOH valuejet 1614 User Manual

Users Guide ValueJet 1614
76 AP-75790  Rev 1.4 -22/02/2011,
4.7.1.11 Dryer menu
Notes
Temperature to be set for the after Heater varies depending on the media which is used. For
recommended temperature settings of the after heater, refer to the "Recommended media list".
Setup Item Setting Value Description
After Heater
OFF / <30° C> to 50° C
Set up the after Heater temperature.
î í
ï
1. Roll media
2. Dryer- After heater
3. Print head

[Enter] key: Save the setting and shift to the
previous hierarchy.
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
User media menu
4.7.1.12 Standby Heating menu
Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item Setting Value Description
StandbyHeating
10 min to <60
min> to 240 min
Sets the length of time to preheat the heaters. When more than
the set time has passed, each heater switches off

[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
User media menu
4.7.1.13 Vacuum Fan menu
Setup Item Setting Value Description
Vacuum Fan
Low Set when using soft media
<High> Set when regular media is used.

[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
User media menu

MUTOH valuejet 1614 Specifications

General

Brand	MUTOH
Model	valuejet 1614
Category	Printer
Language	English