Users Guide ValueJet 1614
71 AP-75790 Rev 1.4 -22/02/2011,
4.6.2 Panel setup menu overview.
The following items can be found in the Panel setup menu.
Setup item Description
Setup menu Various settings of the printer are configured.
Test print menu Performs a nozzle check of the print head and setup list.
Adjust print menu. Print and adjust test patterns for alignment.
Cleaning menu Perform head cleaning
Selection menu set up the contents of the setup menu
Version menu Displays the version of the firmware
Sleep mode menu Sleep mode settings are configured.
For details regarding the setup menu, refer to Panel setup menu
4.7 PANEL SETUP MENU
In the table below you will find the complete menu structure and its function:
Setup item Description
Set1: MediaType Set up the media type for printing.
Set2: Effect Set up the Effect menu.
Set3: Flushing Set up the Flushing operation while printing.
Set4: Side Margin Set up the right and left margin when printing.
Set5: Media Initial
Set up whether the media width and edge are detected when initializing the
media.
Set6: Media Width /
MediaWidth Check
Specifies the media width between the loading mark and the left end if media
detection is not performed during media initialization.
Displays the detected media width if media detection is performed during media
initialization.
Set9: Origin Set the start position of the printing data.
Set10: Prev. Stick Set up to prevent media from sticking when printing.
Set11: HeadFan Set up head fan operation
Set12: CR Movement Set up the distance to move the print head while printing.
Set13: Overwrite Cnt Set up the Overwrite Cnt per swath.
Set14: Overwrite Wait Set up the waiting time while overwrite printing.
Set15: Slant Check Set up the slanting detection between two consecutive print jobs
Set16: Auto Cleaning Set up the auto cleaning time while printing.
Set17: Ink Status
Display the remaining ink level of the ink cassette that was installed into the ink
cassette slot.
Set18: Roll Length Set up the roll media length.
Set19: Head Wash Perform a head wash
Set20: CR Maintenance Unlocks carriage from home position in order to be able to clean the wiper.
Set21: Initialization The parameter values of the printer are restored to their factory defaults
Set22: Life Times Display the operational life time of each part.
Set23: IP Address Set the IP address of the printer.
Set24: Subnet Mask Set the subnet mask of the printer.
Set25: Gateway Set the Gateway.
Set26: Temporary
The settings of "OFF" or "ALL OFF" in the Selection menu are displayed in the
setup menu temporary.
[Cancel] key: Shift to the previous hierarchy.
To Next Page
Loading...
Need help?
General