Users Guide ValueJet 1614
70 AP-75790 Rev 1.4 -22/02/2011,
Step 6 : The setting in the blinking part on the LCD monitor of the operation panel can be changed. Press
the [+] key or the [-] key to change the setting.
Step 7 : To save the changed setting, press the [ENTER] key on the operation panel.
The setting is saved and the next setup item is displayed.
Notes
If you press the [CANCEL] key, [+] key or the [-] key without pressing the [ENTER] key after changing a
setting, the change will not be saved.
Step 8 : Press the [CANCEL] key on the operation panel to exit from the setup.
The previous setup menu is displayed.
When the main menu is displayed, the screen turns to Normal.
To Next Page
Loading...
Need help?
General