MUTOH valuejet 1614 - Printing-Related Troubleshooting

Users Guide ValueJet 1614
120 AP-75790  Rev 1.4 -22/02/2011,
6.3.4 Printing-related troubleshooting
Printing is partially stained or incomplete.
Notes
Proper print quality may not be obtained with the media other than the recommended one.
N°
Possible cause Remedy Reference
1
Does the media
include moisture?
Replace it with new media. "Replacing roll media"
2
Are you using the
folded or wrinkled
media?
3
Does the media
bend?
Use the recommended media. When using
media other than the dedicated one, set the
Vacuum Fan menu.
" "Panel setup menu"
The printing position is incorrect (some parts of the media cannot be printed on)
N° Possible cause Remedy Reference
1
Is the loading position
of the media correct?
Set the media correctly. Setting roll media
2
Did you set up the
origin and print
position?
Cancel or reset the settings of the origin and print
position.
"Panel setup menu"
Printing is blurred
N° Possible cause Remedy Reference
1
Are you using the
recommended
media?
Use the recommended media.
2
Are you using thick
or thin media?
Use the recommended media.
3
Is the media printed
on the printing
surface?
Confirm the printing surface of the media and set it
correctly.
Setting media
4
Did you perform an
Alignment?
Perform Alignment. Adjust the print
head
5
Did you perform a
Media feed
compensation?
Perform Media feed compensation. "Media feed
compensation"
6
Is each heater set to
the appropriate
temperature?
Set it to the appropriate temperature. "Panel setup menu"
7
Is the head height
set to High?
Return the head height to "Normal (Low)". "Head height
adjustment"