MUTOH valuejet 1614 - Print Mode Menu; Dist.adj Menu

Users Guide ValueJet 1614
73 AP-75790  Rev 1.4 -22/02/2011,
4.7.1.2 Print Mode menu
Set up the printing mode according to the used print data or print speed.
print mode
Resolution
Print Passes Dir
Drop Family/
Drop Size
(2)
Head
Speed
(3)
Max. Print Width (mm)
Head Media
quality1 1440 1440 16 uni VSD3d-S Slow 1615
quality2 1440 720 8 uni VSD3d-V Slow 1615
quality3 720 720 8 uni VSD3d-V Slow 1615
quality4 720 720 8 bi VSD3d-V Slow 1615
quality5
(1)
720 720 8 bi VSD3d-V Slow 1615
graphics1 720 720 8 uni VSD3d-V Fast 1615
graphics2 720 720 8 bi VSD3d-V Fast 1615
graphics3
(1)
720 720 8 bi VSD3d-V Fast 1615
banner1 540 720 6 uni VSD1d-V Fast 1615
banner2 540 720 6 bi VSD1d-V Fast 1615
banner3 720 720 4 uni VSD1d-V Slow 1615
banner4 720 720 4 bi VSD1d-M Fast 1615
Remark:
(1)
Print modes only selectable via RIP and not visible on the CS9160 panel
(2)
Large Drop Family - VSD1 : 7  14  21 ng / Small Drop Family - VSD3 : 3.5  7  12.5 ng
(3)
Head speed: Slow = 320 cps = 610 mm/s and Fast = ± 400 cps = 1016 mm/s
cps = 0.1 inch per second. For Unidir: return speed = 400 Cps
(4)
If I² is switched OFF, the print speed increases by approximately 4%.
4.7.1.3 Dist.Adj menu
Various settings on the Media feed compensation can be set.
Setup Item Setting Value Description
PF
Init.Adj.Print
Perform the initial adjust print.
[Enter] key: Shift to the next hierarchy.
Init.Adj.Change Set up Initial Adjust Change.
[Enter] key: Shift to the next hierarchy.
Confirm Print Perform the Confirm Print.
[Enter] key: Shift to the next hierarchy.
Micro Adj. Print Perform the Micro Adjustment Print.
[Enter] key: Shift to the next hierarchy.
Micro Adj.Change Set up the Micro Adjustment Change.
[Enter] key: Shift to the next hierarchy.
 [Cancel] key: Shift to the previous hierarchy.