Users Guide ValueJet 1614
94 AP-75790 Rev 1.4 -22/02/2011,
4.8.5.2 Settings that can be changed or confirmed while printing.
Notes
The Print start menu is displayed only when the printer is warming up.
When you change a setting during operation, be sure to select Backup to save the setting that you
changed.
If the printer returns to Normal without Backup being selected, the changed setting is not saved
Setup Item Setting Description
Print Start ----
[ENTER] key: if the heater temperature does not
reach the set value during warming-up, printing
starts.
Temperature
Pre Check the current Pre Heater temperature.
Platen Check the current Platen Heater temperature
After Check the current After Heater temperature
Pre Heater OFF / 30°C to 50°C Change the Pre Heater temperature
Platen Heater OFF / 30°C to 50°C Change the Platen Heater temperature
After Heater OFF / 30°C to 50°C Change the After Heater temperature
PF Adjust -20 pulse to 0 to 20 pulse Change the feed adjustment value
Backup ---- [ENTER] key: Save the changed setting.
---- [CANCEL] key: the printer returns to normal.
Be sure to read and understand the safety warnings before handling the printer.
To Next Page
Loading...
Need help?
General