Users Guide ValueJet 1614
118 AP-75790 Rev 1.4 -22/02/2011,
6.3.3 Media-related troubleshooting
The media slips or is torn during initialization.
Notes
If the media is jammed or torn, remove it according to when media is jammed
N° Possible cause remedy Reference
1 Are you using the recommended media? Use the recommended
media.
2 Is the loading position of the media correct? Set the media correctly. Setting roll media
3
Is the roll media set correctly? Set the roll media
correctly.
Loading roll media
4
Are there any foreign materials such as paper
attached to the pressure roller?
Clean the pressure roller. Cleaning the inside of the
printer
5
Is the printer being used in an environment
other than the one specified, such as in direct
sunlight?
Only use the printer in an
environment that is
specified for use.
Installation manual
6
Are you using folded, torn or rolled media? Replace the media. Cautions on handling
media"
7
Does the media bend? Use the recommended
media. When using
media other than the
dedicated one, set the
Vacuum Fan menu.
Panel setup menu"
The media is crumpled during initialization.
Notes
If the media is jammed or torn, remove it according to when media is jammed
N° Possible cause Remedy Reference
1
Are you using the recommended media? Use the recommended
media.
2 Is the loading position of the media correct? Set the media correctly. Setting roll media
3 Is the media loaded at an angle? Set the media straight. Setting roll media
4
Are there any foreign materials such as paper
attached to the pressure roller?
Clean the pressure roller. Cleaning the inside of
the printer
5
Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
Only use the printer in an
environment that is
specified for use.
Installation manual
6
Are you using folded, torn or rolled media? Replace the media. "Cautions on handling
media"
To Next Page
Loading...
Need help?
General