Users Guide ValueJet 1614
54 AP-75790 Rev 1.4 -22/02/2011,
4.3.5 Step adjustment
After every printed swath, the media is fed a certain distance. Depending on the kind of media (weight,
backing) another media feed compensation has to be set. This to avoid the following phenomenon:
Printed swaths overlap.
White lines between every swath.
In such cases, follow the procedure below and adjust the media feed compensation value.
Step 1 : Display the Media feed compensation menu on the operation panel.
Step 2 : Press the [Menu] key on the operation panel.
Shift to the Setup menu display.
The operation panel displays "Menu 1: Setup>".
Step 3 : Press the [>] key on the operation panel.
The operation panel displays "Set1: MediaType".
Step 4 : Press the [Enter] key on the operation panel.
The operation panel displays "Media: Type 1".
Step 5 : Press the [+] key or [] key to select the media type you wish to use.
Step 6 : Press the [Enter] key on the operation panel.
The operation panel displays "**>1: Print Mode".
Notes
The selected media (Type 1-30) is displayed in "**". Please refer to Media Type menu
Press the [+] key or [] key to select "**>2: PF Adjust>".
Press the [>] key on the operation panel.
± The operation panel displays "PF1: Initial Print".
To Next Page
Loading...
Need help?
General