Users Guide ValueJet 1614
111 AP-75790 Rev 1.4 -22/02/2011,
6.1.2 Adjust the print head
Notes
This printer was adjusted at factory shipment so that it obtains the optimum print quality.
Adjust the quality if the print quality change after the installation environment or the media is changed.
Be sure to read and understand the safety warnings before handling the printer.
Step 1 : Switch ON the printer and load the roll media.
Refer to: Setting roll media
Step 2 : Confirm that the printer functions normally.
Step 3 : Display the printing mode menu on the operation panel.
Step 4 : Press the [Menu] key on the operation panel.
Menu1: Setup> is displayed on the operation panel.
The operation panel shifts to the Setup menu display.
Step 5 : Press the [>] key on the operation panel.
Set1: MediaType is displayed on the operation panel.
Step 6 : Press the [ENTER] key on the operation panel.
Media: Type1 is displayed on the operation panel.
Step 7 : Press the [+] key or the [-] key on the operation panel to select the media type to use.
Step 8 : Press the [ENTER] key on the operation panel
**>1: print mode is displayed on the operation panel.
Notes
The selected media is displayed in **. For more information please contact your local Mutoh dealer
Step 9 : Press the [ENTER] key on the operation panel.
Mode: graphics 1 -> is displayed on the operation panel.
The display shifts to the printing mode menu.
Step 10 : Select the printing mode that you want to use.
Step 11 : Press the [+] key or the [-] key on the operation panel to select the printing mode to use.
Step 12 : Press the [cancel] key on the operation panel several times.
The operation panel returns to Normal.
Step 13 : Display the Adjust Print menu on the operation panel.
Step 14 : Press the [Menu] key on the operation panel.
Menu 1: Setup> is displayed on the operation panel.
The operation panel shifts to the Setup men display.
Step 15 : Press the [+] key or the [-] key to select Menu3: Adjust Print>
To Next Page
Loading...
Need help?
General