Users Guide ValueJet 1614
14 AP-75790 Rev 1.4 -22/02/2011,
Pay attention when you cut roll media. Mishandling the razor blade may cause a cut in your finger or
hand.
± When you hold media, do not place your finger on the media cut groove.
± Move the razor blade along the media cut groove.
Be sure to switch OFF the power, and disconnect the power plugs when cleaning the printer.
Follow the instructions below when handling the power plugs. Otherwise, fire may occur.
± Wipe away dust and any other residue before inserting the plugs.
± Ensure that the plugs are firmly inserted as far as it will go.
Ensure that the plugs have been disconnected from the power sockets when they are not used for a long
time.
Do not drop waste fluid when replacing the spitting-box sponges. If waste fluid comes into contact with
the grid roller, the surface of the grid roller will be damaged, and the media feed function may be affected.
When cleaning around the print head
± Do not touch the nozzle of the print head; doing so may damage the print head.
± Do not touch the head of the cleaning stick, oil on your hands may attach to the cleaning stick,
causing damage to the print head.
± Do not immerse the head of the cleaning stick in water; doing so may damage the print head.
± Do not reuse the cleaning stick; dust attached to the stick may damage the print head.
To Next Page
Loading...
Need help?
General