VJ-1624/1624W OPERATION MANUAL 7 Troubleshooting
7-7
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
(3) Printing is blurred
No. Possible cause Remedy Reference
1 Is the loading position of the media correct? Load the media correctly.
3.4.2 Setting
Roll Media
2 Did you set up the origin and print position? Cancel or reset the settings of the origin and
print position.
5.1.8 Origin
menu
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Are you using the thick or thin media? Use the recommended media.
4.2.1 Media type
3 Is the media printed on the printing surface? Confirm the printing surface of the media and
set it correctly.
3.4 Loading
media
4 Did you perform Micro adjust print? Perform Adjust print.
3.6 Print quality
adjustment
5 Did you perform Media feed compensation? Perform Media feed compensation.
4.2.6 Media feed
compensation
6 Is the temperature setting of each heater
appropriate?
(VJ-1624 only)
Set the temperature appropriately.
5.1.1.1.4 Pre-
heater menu (VJ-
1624 only) to
5.1.1.1.6 Dryer menu
(VJ-1624 only)
7 Is the head height set to "High" or "Mid"? Return the head height to "Low".
4.2.5 Head
height adjustment
To Next Page
Loading...
Need help?
General