MYDATA MY500 JetPrinter Routine Maintenance
P-030-0014-EN – Service Manual Rev. 0003 2008-06 5 - 21
Maintenance Tables
This section shows the previous described maintenance as tables that can be
copied and used as service protocols.
Daily Maintenance
Weekly Maintenance
Place Maintenance action Completed
Cassette – Inspect the cassette holder for wear or damage.
– Wipe off any solder paste from the holder´s backside.
– Wipe off any solder paste from the nozzle.
Machine – Wipe off any solder paste from the cassette interface.
– Wipe off any solder paste from the Conveyor table.
Calibration units – Inspect the height calibration point, clean if necessary.
– Inspect the waste container, empty if necessary.
– Inspect the quantity of paper. Reload if necessary.
– Wipe off any solder paste from the camera calibration
unit.
Filters – Check the air filter indicator.
Optional Refrigerated
Air Dryer
– Check the auto drain.
Place Maintenance action Completed
Machine – Clean X- and Y-Linear scales.
– Rear Hood closed.
Others – Wipe off touch screen.
– Check warning signs.
To Next Page
Loading...