MYDATA MY500 JetPrinter - Unpacking

MYDATA MY500 JetPrinter Installation
P-030-0014-EN – Service Manual Rev. 0003 2008-06 2 - 9
Unpacking
The machine is shipped in a wooden crate (outside Europe) and must be
handled with care. It is strongly recommended that a MYDATA representative
is present when the machine is unpacked.
1. Inspect the ’Shock Watch’ and ’Tilt Watch’ gages for activation and the
crate for damages. These must be annotated on the Bill of Lading and
goods received note.
2. Remove the top lid.
3. Remove the rear and front sides of the box.
4. Remove the plastic protection.
5. Remove additional packages fastened to the machine (for instance
monitor, keyboard, and offline PC).
6. Release the machine from the bottom of the box.
7. Inventory all packages to ensure that the correct items are delivered
according to the packing list. If not, contact your local MYDATA
representative.
Items that are always included:
– Power cable.
– Monitor, keyboard and trackball.
– Offline PC (with cables).
– Spare part kit.
– Calibration tools
L-030-0119 Conveyor calibration card.
D-007-0728 Calibration ruler.
L-038-0193 Height reference tool.
– Operator’s manual.
– Programming manual.
– Service manual.