MYDATA MY500 JetPrinter - Environmental Requirements

MYDATA MY500 JetPrinter Installation
P-030-0014-EN – Service Manual Rev. 0003 2008-06 2 - 5
Figure 2-3 shows a top view over the required service area around the machine
(measurements in mm). Also the position of the network and power inlets are
shown in the figure. Note that there is no specific area required on the sides of
the machine. It is sufficient to be able to pass around to the backside.
Figure 2-4 shows the space required above the machine.
If you have the optional Air Cooling unit, this will require a minimum distance
of 400 mm to the nearest wall or machine.
Environmental Requirements
Temperature
Operating: +18 to +30 °C with full performance.
+5 to +18 °C and +30 to +40 °C with no guarantee of the
accuracy.
Storage: –30 to +65 °C
Relative humidity
Operating: <95 %, non-condensing
Storage: 100 %
Altitude
The MY500 JetPrinter is capable to operate correctly at altitudes up to 1 000 m
above mean sea level.
Dust and dirt
The machine does not require a clean-room environment but dust and dirt must
be kept as low as possible. The maintenance intervals are shortened by high
temperature and dusty or dirty environment.
Figure 2-4. Clear space above the machine.
750 mm