MYDATA MY500 JetPrinter Safety
P-030-0014-EN – Service Manual Rev. 0003 2008-06 1 - 1
1. Safety
Before starting the machine, personnel involved in the machine operation,
maintenance or service must understand and follow these points:
• This machine is designed to apply solder paste and glue onto printed wiring
boards. The machine must be used exclusively for this purpose and nothing
else.
• The machine must be operated by qualified personnel only. Qualified
personnel should meet the following qualifications:
– Be above 18 years of age.
– Have normal depth perception, field of vision, reaction time, manual
dexterity, coordination, and no tendency to dizziness.
– Completed operators training.
• All personnel involved in machine operation must understand the use of the
emergency stop buttons. See the Emergency Stop Buttons section.
• Anyone operating this machine must obey the warning signs.
• At least one manual describing the warning signs of the particular machine
type must always be kept. For instance if the machine is upgraded to a later
version.
• An emergency stop button must be pressed down when a solder paste
cassette is manually inserted or removed.
• If there is a risk that any unauthorized personnel may alter the system
settings and thus the behavior of the machine, the logon facility for
individual access rights must be used.
• Ensure that all covers and shields are intact, mounted, and closed while the
machine is in operation.
• Do not disable or disengage any safety switch or sensor.
• Do not configure or modify MYDATA machines or devices without
consulting MYDATA. The machines, devices or the interfaces between
them might become unsafe.
• Do not use chemicals or other substances which may have any influence on
the operator or other personnel involved in the machine operation.
To Next Page
Loading...