MYDATA MY500 JetPrinter - Installation Summary and Steps

MYDATA MY500 JetPrinter Installation
P-030-0014-EN – Service Manual Rev. 0003 2008-06 2 - 7
Installation
Upon arrival the machine must be unpacked, lifted, moved to the machine site
and leveled.
This section describes how to perform the installation tasks and is divided into
the following main parts:
– Unpacking on page 2-9.
– Lifting the Machine on page 2-10.
– Moving and Placing the Machine on page 2-12.
– Powering on page 2-14.
– Network Connection on page 2-19.
– Software Installation on page 2-22.
Equipment
•
Standard tools.
• Set of Allen Keys (mm).
• Spirit level and 70mm wrench.
• Lifting equipment.
• Calibration tools:
– L-030-0119 Conveyor calibration card.
– D-007-0728 Calibration ruler.
– L-038-0193 Height reference tool.