Installation MY500 JetPrinter MYDATA
2 - 8 Rev. 0003 2008-06 P-030-0014-EN – Service Manual
Installation Summary
This is a summary of the installation process of a MY500 JetPrinter:
– Unpack the machine and all other packages.
– Check the ’Shock Watch’ and ’Tilt Watch’ gages.
– Check that all ordered parts are delivered.
– Place the machine at the desired position.
– Make sure that the machine is level, and that all machine’s feet make
contact with the floor.
– Attach the desired plug to the 1 phase cable.
Before connecting the input power verify that it is the same as the
label on the back door.
– Connect air through cooling unit or optional filter unit.
Ensure that pressure is 7 bar.
– Switch on the machine power.
– Check the voltage with the Service program.
– Use Service program to check all safety switches (hoods & emergency
buttons).
–Run HardwareInstall.
– Check the surrounding equipment that follows with the machine, i.e.
Light tower.
– Install the barcode scanner.
– Make a backup.
To Next Page
Loading...