CHAPTER 3 SYSTEM DATA PROGRAMMING
– 90 – NWA-008853-001 Rev.3.0
97ch3001.fm
HOW TO READ THIS CHAPTER
This chapter explains the feature programming for each service feature about the following Abbreviations.
(1) : 1st data
(2) : 2nd data
: Initial data; With the system data clear command (CM00, CM01), the data with this marking is
automatically set for each command.
: A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
: A reset of the AP00 card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
: A reset of the DTI card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
: Command with this marking can be used only under Off-Line mode of the MP
card.
To set Off-Line mode,
(1) Set SW3 on the MP card to “2” or “3”.
(2) Press SW1 on the MP card.
: Command with this marking can be used only under Off-Line mode of the AP00
card.
INITIAL
AP00 INITIAL
DTI INITIAL
OFF LINE
AP OFF LINE
HOW TO READ THIS CHAPTER
To Next Page
Loading...
