CHAPTER 3 SYSTEM DATA PROGRAMMING
– 180 – NWA-008853-001 Rev.3.0
97ch3002.fm
CALLING NAME DISPLAY-CCIS
General Description
This feature permits the station name of a calling or called party at another switching office, through the
CCIS network, to be displayed either on a D
term
or an Attendant Console.
Programming
DESCRIPTION DATA
Provide the system with the Name Display ser-
vice.
(1)
(2)
255: Name Display
1: To provide
Specify the number of digits sent to the CCIS
network to 24 digits.
(1)
(2)
379: Number of dialed digits
0: 24 digits
Specify the time to go back to date and time
display after the call is answered.
(1)
(2)
120
0 : 10 seconds later
1 : 6 seconds later
Specify the duration to display the name. (1)
(2)
121
0 : Until call finished
1 : As per CM08>120
Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300 software required]
Specify the duration of displaying the destina-
tion information when the outgoing call is an-
swered by the destination via CCIS.
[Series 3300 software required]
(1)
(2)
(1)
(2)
537
0 : Until call is finished/key is pressed
again
1 : 6 seconds
538
0 : Until call is finished
1 : 6 seconds
Assign the access code for station user name
entry from an individual station.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code (0-9, *, #)
A110
Assign a trunk name number to each trunk
route.
•
(1)
(2)
Y=03
00-63: Trunk Route No.
00-14: Trunk Name No.
15 : Kind of trunk route assigned by
CM35 Y=00 are displayed
16-63: Trunk Name No.
START
CM08
CM20
CM35
A
CALLING NAME DISPLAY-CCIS
To Next Page
Loading...
