NEC NEAX 2000 IPS - Direct-In Termination-Ccis

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 264 – NWA-008853-001 Rev.3.0
97ch3004.fm
DIRECT-IN TERMINATION-CCIS
General Description
This feature automatically routes incoming exchange calls through CCIS to a preassigned station in the
network, without Attendant assistance.
Programming
• When a release signal arrives on the incoming (IC) trunk
DESCRIPTION DATA
Assign the data for terminating system in Day
Mode, Night Mode, Mode A and Mode B of
the trunk, respectively.
•
•
•
•
(1)
(2)
Y=02 Day Mode
Y=03 Night Mode
Y=40 Mode A
Y=41 Mode B
000-255: Trunk No.
04: Direct-In Termination
Assign the Abbreviated Code for System
Speed Dialing to terminate the Satellite Office
via CCIS by DTI in Day Mode, Night Mode,
Mode A and Mode B, respectively.
•
•
•
•
(1)
(2)
Y=04 Day Mode
Y=05 Night Mode
Y=42 Mode A
Y=43 Mode B
000-255: Trunk No.
CXX
XX: 00-31 (Abbreviated Code for System
Speed Dialing assigned by
CM71>66)
Assign trunk route data to the trunk route num-
ber (for IC route).
•
(1)
(2)
Y=02 IC/BW
00-63: Trunk Route No.
1 : Incoming Trunk
3 : Bothway Trunk
•
(1)
(2)
Y=05
Release Signal from Distant Office
00-63: Trunk Route No.
1 : Arrive
•
(1)
(2)
Y=09 Incoming Connection Signaling
00-63: Trunk Route No.
15 : Ring Down
START
CM30
CM35
A
DIRECT-IN TERMINATION-CCIS