NEC NEAX 2000 IPS - Page 279

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 265 – NWA-008853-001 Rev.3.0
97ch3004.fm
DESCRIPTION DATA
Specify the combination of trunk routes allow-
ing the Tandem connection.
•
(1)
(2)
Y=0
XX ZZ
XX: 00-63 (Incoming Trunk Route)
ZZ : 00-63 (Outgoing Trunk Route for
CCIS)
0: Allow
Assign the System Speed Dialing memory area
used exclusively for DIT-Outside.
(1)
(2)
66: Exclusive for DIT-Outside
XXX YYY
XXX: 000-299 (Starting Memory Slot No.
in Block)
YYY: 001-300 (No. of Slots to be
assigned in Block)
NONE : No data
Set the stored number to the Memory Slot
number allocated by CM71.
•
(1)
(2)
Y=0
000-299: Memory Slot No.
XXXX YY...Y
XXXX : Access Code (Maximum 4 digits)
: Separator Mark
YY...Y : Calling Party’s No.
(Maximum 26 digits)
A
CM36
CM71
CM72
,
,
END
JANUARY/31/2006
DIRECT-IN TERMINATION-CCIS