CHAPTER 3 SYSTEM DATA PROGRAMMING
– 341 – NWA-008853-001 Rev.3.0
97ch3005.fm
VOICE CALL-CCIS
General Description
This feature provides a voice path, through the CCIS network, between a D
term
in one office and a D
term
in another office. This path is established from the calling party to the called party’s built-in speaker. If
the called party’s MIC lamp is on, the called party can have a conversation in hands-free.
Programming
Operating Procedure
From a D
term
to another D
term
:
1. The originating D
term
user dials the desired station number in another office, and receives ring
back tone.
2. The calling party presses the Voice Call feature key.
A signal tone is transmitted over the CCIS network to the called party’s speaker.
The calling party’s LCD shows:
3. The called party presses the MIC key (if the MIC LED is not lit) to allow two-way conversation
with the calling party.
DESCRIPTION DATA
Assign a Voice Call key to the D
term
.•
(1)
(2)
Y=00
My Line No. + + Key No.
F1002: Voice Call
START
CM90
,
END
Called D
term
VOICE CALL XXXX
(TIME DISPLAY)
VOICE CALL-CCIS
To Next Page
Loading...
