CHAPTER 3 SYSTEM DATA PROGRAMMING
– 307 – NWA-008853-001 Rev.3.0
97ch3005.fm
OUTGOING TRUNK QUEUING-CCIS
General Description
This feature allows a CCIS network station, upon encountering an all trunks busy signal, to dial a speci-
fied access code and enter a first-in, first-out queue. As soon as a CCIS trunk becomes available, stations
in the queue will be called back on a first-come, first-served basis.
NOTE: This feature applies to the tie line trunks between the two PBX systems and not to the outgoing
trunks at the remote PBX.
Programming
DESCRIPTION DATA
Assign Service Restriction Class A to the re-
quired stations.
•
(1)
(2)
Y=02
X-XXXXXXXX: Station No.
XX ZZ
XX: 00-15 : Service Restriction Class A
Allow Outgoing Trunk Queuing in Service Re-
striction Class A assigned by CM12 Y=02.
•
(1)
(2)
Y=02
00-15: Service Restriction Class A as-
signed by CM12 Y=02
1 : Allow
Assign access code for setting and resetting
this service.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
• Different access code from Call Back
A000: Set
A001: Reset
• Same access code as Call Back
A004: Set
A005: Reset
Assign the Trunk Queuing-OG (Call Back)
key to the required D
term
.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0004
Specify the Trunk Queuing-Outgoing capabil-
ity to each trunk route.
•
(1)
(2)
Y=28
00-63: Trunk Route No.
0 : Restricted
1 : Allow
START
CM12
CM15
CM20
CM90
,
CM35
END
OUTGOING TRUNK QUEUING-CCIS
To Next Page
Loading...
