CHAPTER 3 SYSTEM DATA PROGRAMMING
– 262 – NWA-008853-001 Rev.3.0
97ch3004.fm
DIAL ACCESS TO ATTENDANT-CCIS
General Description
This feature allows a station user to call an Attendant Console by dialing an operator call code through
the CCIS network.
Programming
DESCRIPTION DATA
Specify the tenants to be handled by each AT-
TCON Group.
NOTE: When marking a link with the 2400
IPX Tenant number should be as-
signed as 01-63, not 00.
•
(1)
(2)
Y=0-3: ATTCON Group 0-3 assigned by
CM60 Y=00
00-63: Tenant No.
0 : To handle
1 : Not handled
Assign the digit 0 as an access code, to LCR
Group 3 (A129).
•
(1)
(2)
Y=0: Number Plan Group 0-3
0: Access Code
A129
Assign an area code table to be used to select a
route pattern table.
•
(1)
(2)
Y=A000
0-3: LCR Group 0-3
4005-4007: Area Code Development Pat-
tern No. 5-7
Assign the digit 0 into the selected area code
table.
•
(1)
(2)
Y=4005-4007
0
0000-0255: Route Pattern No. 000-255
Assign the next Route Pattern number to the
Route Pattern number assigned by CM8A
Y=4005-4007.
NOTE: This data is required to expand the
order of LCR selection that is as-
signed by CM8A Y=0000-0255.
The order of LCR selection can be
expand to the maximum seventh.
•
(1)
(2)
Y=0000-0255 Route Pattern No.000-255
0: Designation of next table
0000-0255: Next Route Pattern No.000-
255
START
CM62
INITIAL
CM20
CM8A
A
DIAL ACCESS TO ATTENDANT-CCIS
To Next Page
Loading...
