CHAPTER 3 SYSTEM DATA PROGRAMMING
– 263 – NWA-008853-001 Rev.3.0
97ch3004.fm
Operating Procedure
To call an Attendant Console:
1. The station user dials the operator call code and receives ringback tone.
2. The ATND lamp for Incoming Call Identification flashes on the Attendant Console. The Attendant
answers the call.
DESCRIPTION DATA
Assign the route pattern table with the desired
properties and selection of appropriate routes.
•
(1)
(2)
Y=0000-0255: Route Pattern No. 000-255
1-4: Order of LCR Selection
1: 1st
2: 2nd
3: 3rd
4: 4th
XXX ZZ
XXX : 000-255 (LCR Pattern No.)
ZZ : 00-63 (Trunk Route No.)
A
CM8A
END
DIAL ACCESS TO ATTENDANT-CCIS
To Next Page
Loading...
