CHAPTER 2 INSTALLATION
ā 78 ā NWA-008853-001 Rev.3.0
97ch2001.fm
Cable Connection via CONN Card
When using a coaxial cable, connect the cable to a CSU via the CONN (PZ-M542/PZ-M557) card as
shown below.
The figure in next page shows an example of the cable connection when the DTI/CCT card is mounted in
the AP05 slot of PIM0.
Cable Connection via CONN Card
CSU
LTC0/LTC1/LTC2/LTC3 CONNECTOR
COAXIAL CABLE
DTI/CCT
BWB
PBX
MAXIMUM 6 dB loss at 1024 kHz
CONN (PZ-M542/PZ-M557)
INSTALLATION PROCEDURE FOR DIGITAL CCIS
To Next Page
Loading...
