NEC NEAX 2000 IPS - Inter-Tenant Connection Assignment

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 111 – NWA-008853-001 Rev.3.0
97ch3001.fm
Inter-Tenant Connection Assignment
DESCRIPTION DATA
Assign the tenant number to each station.
NOTE: When linking with the 2400 IPX, the
tenant number for the 2000 IPS
should be assigned as 01-63. 00 is
not used.
•
(1)
(2)
Y=04
X-XXXXXXXX: Station No.
00-63: Tenant No. 00-63
01 : Tenant No. 01
Assign the tenant number to each trunk.
NOTE: When linking with the 2400 IPX, the
tenant number for the 2000 IPS
should be assigned as 01-63. 00 is
not used.
•
(1)
(2)
Y=01
000-254: Trunk No.
00-63: Tenant No. 00-63
01 : Tenant No. 01
Specify the inter-tenant connection for station-
to-station calling or incoming call termination.
(See Example 1, 2 in the following pages.)
•
(1)
(2)
Y=1 Station-to-Station Calling
XX ZZ
XX: 00-63: Tenant No. of Calling Station
ZZ : 00-63: Tenant No. of Called Station
0 : Restricted
1 : Allow
•
(1)
(2)
Y=2 Incoming Call Termination
XX ZZ
XX: 00-63: Tenant No. of Called Station
ZZ : 00-63: Tenant No. of Trunk
0 : Restricted
1 : Allow
START
CM12
CM30
CM63
END
DIGITAL CCIS PROGRAMMING