NEC NEAX 2000 IPS - Message Waiting Lamp Setting-Attendant-Ccis

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 291 – NWA-008853-001 Rev.3.0
97ch3004.fm
MESSAGE WAITING LAMP SETTING-ATTENDANT-CCIS
General Description
This feature allows an Attendant, in the 2400 IPX, to set or cancel a Message Waiting lamp indication,
through the CCIS network, on a station in 2000 IPS.
Programming
Hardware Required
To provide a Single-Line Telephone with Message Waiting lamp:
• LC (PN-4LCD/4LCF) card
Operating Procedure
To set a Message Waiting indication:
1. Press an idle LOOP key and receive dial tone.
2. Dial the Message Waiting feature access code (maximum of three digits) and receive Feature Dial
Tone.
3. Dial the station number and receive Service Set Tone.
4. Message Waiting indication is set.
5. Press the RELEASE key to return to an idle condition.
To cancel a Message Waiting indication:
1. Press an idle LOOP key and receive dial tone.
2. Dial the Message Waiting cancellation code (maximum of three digits) and receive Feature Dial
Tone.
3. Dial the station number and receive Service Set Tone.
4. Message Waiting indication is canceled.
5. Press the CANCL key to return to an idle condition.
DESCRIPTION DATA
Provide each station with Message Waiting
service.
•
(1)
(2)
Y=03
X-XXXXXXXX: Station No.
0: To provide
START
CM13
END
MESSAGE WAITING LAMP SETTING-ATTENDANT-CCIS