CHAPTER 3 SYSTEM DATA PROGRAMMING
– 135 – NWA-008853-001 Rev.3.0
97ch3001.fm
CCH Assignment
Follow the same programming procedure as shown in “CCH Assignment” in DIGITAL CCIS
PROGRAMMING. Page 103
Note that the assignment of trunk number by CMA7 Y=00 is not required when the CCH is connected with
a dedicated line. CMA7 Y=00 is required when the common signaling channel is connected via an LDT/
ODT card.
Numbering Plan Assignment
Follow the same programming procedure as shown in “Numbering Plan Assignment” in DIGITAL CCIS
PROGRAMMING. Page 105
Inter-Tenant Connection Assignment
Follow the same programming procedure as shown in “Inter-Tenant Connection Assignment” in DIGITAL
CCIS PROGRAMMING. Page 111
Route Advance Assignment
Follow the same programming procedure as shown in “Route Advance Assignment” in DIGITAL CCIS
PROGRAMMING. Page 124
JANUARY/31/2006
ANALOG CCIS PROGRAMMING
To Next Page
Loading...
