CHAPTER 3 SYSTEM DATA PROGRAMMING
ā 179 ā NWA-008853-001 Rev.3.0
97ch3002.fm
NOTE 1: In the Inter-Tenant Connection Assignment, the Tenant number should be assigned as 01-63.
00 should not be used if connecting to a PBX.
NOTE 2: Refer to Numbering Plan Assignment and assign a dial code to call the attendant by the LCR
feature.
Operating Procedure
To transfer a call to an Attendant Console:
1. While engaged in a Central Office trunk call, press the hookswitch momentarily and receive Feature
Dial Tone.
2. Dial the operator access code.
3. The ATND lamp on the Attendant Console flashes and the buzzer sounds. The station receives ring-
back tone.
To answer from the Attendant Console:
1. Refer to the Attendant Console Userās Guide.
If the station wishes to return to the Central Office trunk call while the Attendant Console is being
called:
1. Press the hookswitch momentarily. The ATND lamp on the Attendant Console goes out and the
buzzer stops.
2. Ringback tone ceases and the station returns to the Central Office trunk call.
CALL TRANSFER-ATTENDANT-CCIS
To Next Page
Loading...
