NEC NEAX 2000 IPS - Page 118

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 104 – NWA-008853-001 Rev.3.0
97ch3001.fm
DESCRIPTION DATA
Assign a Destination Point Code (DPC) to
each CCH number.
NOTE: The Destination Point Code is used
to designate a terminating office in
the No. 7 CCIS network. Usually a
different DPC is assigned to each
CCH number in the same system.
•
(1)
(2)
Y=02
0-7: CCH No.
00001-16367: DPC
Assign the Point Code of the Centralized Fault
Reporting office, if required.
•
(1)
(2)
Y=05
0-7: CCH No.
00001-16367: Point Code of Centralized
Fault Reporting office
Assign the originating office number to each
CCH number, if required.
NOTE: This data setting is required only for
open numbering system.
•
(1)
(2)
Y=06
0-7: CCH No.
0000-9999: Office No.
Assign the CCH number to which a signaling
message is transferred according to the Point
Code received.
Up to 256 point codes can be assigned.
(1)
(2)
00001-16367: DPC
0-7: CCH No.
Select the CCH for CCIS. •
(1)
(2)
Y=14
04-15, 20-31: AP No. assigned by CM05
Y=0
0 : PN-24CCTA/PN-30CCTA/PN-DTA
(Built-in CCH)
1 : PN-SC00 (CCH)
Specify the type of the CCT card. •
(1)
(2)
Y=15
04-15, 20-31: AP No. assigned by CM05
Y=0
0 : PN-30CCTA
1 : PN-24CCTA
A
CMA7
CMA8
CMAA
END
JULY/01/2006
DIGITAL CCIS PROGRAMMING