NEC NEAX 2000 IPS - Page 122

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 108 – NWA-008853-001 Rev.3.0
97ch3001.fm
• For closed numbering system
DESCRIPTION DATA
Assign the access code for LCR Group 3. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
A129: LCR Group 3
When providing Centralized MAT or Network
Station Number (FCCS), assign the access
code for the number of digits of the network
station number.
NOTE: For Centralized MAT or Number
Portability, this data must be set.
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
811-818: 1-8 digits network station No.
Assign an Area Code Development Pattern
number to the LCR Group selected above.
•
(1)
(2)
Y=A000
0-3: LCR Group 3
4005-4007: Area Code Development Pat-
tern No. 5-7
Assign a Route Pattern number to the digits to
be dialed in the Area Code Development Pat-
tern number assigned by CM8A Y=A000.
NOTE: The digits assigned in CM20 to
A129: LCR Group 3 must be entered
in the Area Code Development Pat-
tern table for access to the desired
Route Pattern number.
•
(1)
(2)
Y=4005-4007 Area Code Development
pattern No. 5-7
X-X---X: Area Code 1-8 digits
0000-0255: Route Pattern No. 000-255
Assign an area code (station number) for intra-
office station, if required.
•
(1)
(2)
Y=4005-4007 Area Code Development
Pattern No. 5-7
X-X---X: Area Code 1-8 digits
8001-8008: 1-8 digits Intra-Office Station
Specify the LCR selection priority for the
Route Pattern number assigned by CM8A
Y=4005-4007.
•
(1)
(2)
Y=0000-0255
Route Pattern No. 000-255
1: 1st priority
2: 2nd priority
3: 3rd priority
4: 4th priority
XXX ZZ
XXX: 000-255: LCR Pattern No.
ZZ : 00-63: Trunk Route No.
START
CM20
CM8A
A
DIGITAL CCIS PROGRAMMING