NEC NEAX 2000 IPS - Page 167

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 153 – NWA-008853-001 Rev.3.0
97ch3002.fm
DESCRIPTION DATA
Allow or restrict Multiple Call Forwarding-All
Calls/Busy Line/Don’t Answer-CCIS for each
CCH number.
•
(1)
(2)
Y=29
0-7: CCH No.
0 : Allowed
1 : Restricted (Only once)
Specify the number of times of Multiple Call
Forwarding-All Calls/Busy Line/Don’t An-
swer-CCIS.
(1)
(2)
72
01-07: 1 time-7 times
If no data is set, the default setting is 5
times.
Provide Call Forwarding feature with each ten-
ant as per incoming call type.
•
•
•
(1)
(2)
Y=23
Internal Call or ATT assisted Call
Y=24 C.O. Incoming Call
Y=25 Tie Line Incoming Call
00-63: Tenant No.
1 : Call Forwarding
Select the Dial Tone on setting Call Forward-
ing-All Calls.
•
(1)
(2)
Y=2
13: Dial Tone on Setting Call Forwarding-
All Calls
0 : Special Dial Tone
1: Dial Tone
Assign the Call Forwarding-All Calls key to a
D
term
, if desired.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0010: Call Forwarding-All Calls Set/Can-
cel
B
CMA7
CM42
CM65
CM48
CM90
,
END
CALL FORWARDING-ALL CALLS-CCIS/MULTIPLE CALL FORWARDING-ALL CALLS-CCIS