CHAPTER 3 SYSTEM DATA PROGRAMMING
– 159 – NWA-008853-001 Rev.3.0
97ch3002.fm
DESCRIPTION DATA
To apply this feature to incoming calls, assign
trunk route combinations for Tandem connec-
tion.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
1 : Release Signal arrives
•
(1)
(2)
Y=0
XX ZZ
XX: 00-63 (Incoming Trunk Route)
ZZ : 00-63 (Outgoing Trunk Route)
0: Allow
Allow Call Forwarding-Outside-CCIS. (1)
(2)
370
1 : Allowed
Specify the Call Forwarding-Busy Line-Out-
side setting operation.
(1)
(2)
222
0 : The feature is set when the station
goes on hook/when receiving Service
Set Tone (ORT time out)
1 : The feature is set when receiving Ser-
vice Set Tone (ORT time out)
Allow or restrict the ability to set Call For-
warding-Busy Line for a station with Do Not
Disturb set.
(1)
(2)
240
0 : Allowed
1 : Restricted
Assign whether an extension can set the desti-
nation of Call Forwarding-Busy Line-Outside
by entering only a trunk access code.
(1)
(2)
386
0 : Restricted
1 : Allowed
Assign whether the system should check the
trunk restriction class of the forwarded station
during Call Forwarding-Busy Line-Outside.
(1)
(2)
387
0 : Follow the trunk restriction class
1: No check
A
CM35
CM36
CM08
B
CALL FORWARDING-BUSY LINE-CCIS/MULTIPLE CALL FORWARDING-BUSY LINE-CCIS
To Next Page
Loading...
