NEC NEAX 2000 IPS - Page 185

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 171 – NWA-008853-001 Rev.3.0
97ch3002.fm
D
term
To set a Call Forwarding-Don’t Answer-CCIS from a D
term
:
1. Lift the handset or press the Speaker key and receive dial tone.
2. Press the Call Forwarding-Don’t Answer feature key and receive Feature Dial Tone.
3. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
4. Dial the desired target station number and receive Service Set Tone.
5. Wait approximately five seconds and receive Service Set Tone. The LED lights. The LCD shows:
6. Replace the handset or press the Speaker key.
To cancel a Call Forwarding-Don’t Answer-CCIS from a D
term
:
1. Lift the handset or press the Speaker key and receive dial tone.
2. Press the Call Forwarding-Don’t Answer feature key. The LCD shows:
3. Dial “ ” and receive Service Set Tone. The LED of the associated feature key will go out. The
LCD shows:
4. Replace the handset or press the Speaker key.
Forwarding station number
SET XXXX
(TIME DISPLAY)
CF NANS YYY
(TIME DISPLAY)
CANCEL
(TIME DISPLAY)
CALL FORWARDING-DON’T ANSWER-CCIS/MULTIPLE CALL FORWARDING-DON’T ANSWER-CCIS