CHAPTER 3 SYSTEM DATA PROGRAMMING
– 177 – NWA-008853-001 Rev.3.0
97ch3002.fm
NOTE: See also the programming for “Trunk to Trunk Connection” in the “Feature Programming
Manual”, when no release signal arrives from the incoming trunk route.
Operating Procedure
To transfer a call in progress from a Single-Line Telephone:
1. Press the hookswitch momentarily and receive Feature Dial Tone.
2. Dial the third party and receive ringback tone.
3. Wait for the third party to answer and announce the transfer while keeping the first party on Con-
sultation Hold-All Calls-CCIS. When the station user hangs up, the first and third parties will be
automatically connected.
To transfer a call in progress from a D
term
:
1. Press the Transfer key and receive Feature Dial Tone.
2. Dial the third party and receive ringback tone.
3. Wait for the third party to answer and announce the transfer while keeping the first party on Con-
sultation Hold-All Calls-CCIS. When the station user hangs up, the first and third parties will be
automatically connected.
DESCRIPTION DATA
Specify Call Transfer from a station before a
called station answers.
(1)
(2)
062
0 : Not available
1 : Available
When a station that has a C.O./Tie line call (via
TRK-A) on Consultation Hold is talking with
an another C.O./Tie line call (via TRK-B),
specify the system operation after the C.O./Tie
line call (via TRK-B) is completed.
[Series 3300 software required]
(1)
(2)
534
0 : Return to the original call (via TRK-A)
1: ROT
A
CM08
END
CALL TRANSFER-ALL CALLS-CCIS
To Next Page
Loading...
