NEC NEAX 2000 IPS - Page 233

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 219 – NWA-008853-001 Rev.3.0
97ch3003.fm
Centralized Billing Programming Steps for Pattern 1
SMDR 0 using Port 0
Local Office A, B uses AP00.
CENTER OFFICE LOCAL OFFICE A/B
CM05 Y=0>XX : 04 (AP00) 04 (AP00)
CMD101>0000 : CCC (Data All Clear) CCC
CMD001>179 : 1 (Center Office) 0 (Local Office)
CMD003>24
>26
>29
: 0 (Not record)
: 0 (Not record)
: No. of call record for SMDR 0
Desired setting
No. of call record Local Office
Desired setting
CMD102>0000 : CCC CCC
CM08>800
>368
>378
: 1 (AP00)
: 0 (Center Office)
: 1 (Not Local Office)
1
1 (Local Office)
0 (Not Center Office)
CMA7 Y=03>0 : 1 (Distant Office is Local Office) 0 (Distant Office is Center Office)
=04>0 : NONE Point Code of Center Office
CMD000>76 : 0 (Tandem Call to SMDR) Default or desired setting
CMD001>239
CM04 Y=01>06
>03
CMD001>20
>21
>22
>23
>80
>81
>82
>84
>85
>86
: 1 (SMDR 0)
: 3 (AP00 with AP00 program)
: 7 (Not sent)
: Data Speed (Port 0)
: Stop Bit (Port 0)
: Data Length (Port 0)
: Parity (Port 0)
: 4 (SMDR 0)
: 0 (Priority)
: 3 (2400 Format)
: 1 (Free Wheel)
: 48 (SA)
: 33 (UA)
0 (Not Centralized Billing Office)
Default
Default
Default
Default
Default
Default
Default
Default
Default
Default
Default
Default
CMD015>XXXX : XX (Station Class No.) XX (Station Class No.)
CMD016>XX31
>XX32
>XX58
>XX16
>XX17
: 0 (C.O. outgoing calls to SMDR)
: 0 (Tie Line outgoing calls to SMDR)
: 0 (C.O./Tie Line incoming calls to SMDR)
: 1 (C.O./Tie Line incoming calls to SMDR 0)
: 0
1
1
1
Desired setting
Desired setting
CMD000>70
>77
>79
: Desired setting
: Desired setting
: Desired setting
Desired setting
Desired setting
Desired setting
CENTRALIZED BILLING-CCIS