NEC NEAX 2000 IPS - Page 291

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 277 – NWA-008853-001 Rev.3.0
97ch3004.fm
Programming
Operating Procedure
No manual operation is required.
DESCRIPTION DATA
Assign a Numbering Plan Group to each Ten-
ant.
(1)
(2)
00-63: Tenant No.
710-713: Numbering Plan Group 0-3
Specify the number of digits for station num-
bers.
Example: For setting station number “2XXX”
(1) 2
(2) 804
NOTE: To the following stations, 5 or more
digits station number must not be
assigned.
• Stations observed by SMDR/
PMS/OAI
• Front Desk Terminal/D
term
TIMS
•
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X: 1st digit of station No.
801: 1 digit
802: 2 digits
803: 3 digits
804: 4 digits
805: 5 digits
806: 6 digits
807: 7 digits
808: 8 digits
Assign station number to the required LEN ac-
cording to the Numbering Plan specified by
CM20.
NOTE: We recommend the setting of station
number by CM14, when using Series
3200 R6.2 software or later.
(1)
(2)
000-763: LEN
X-XXXXXXXX: Station No.
Assign station number to the required LEN ac-
cording to the Numbering Plan specified by
CM20.
[Series 3200 R6.2 software required]
(1)
(2)
XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
X-XXXXXXXX: Station No.
NONE : No data
START
CM29
CM20
CM10
CM14
END
FLEXIBLE NUMBERING OF STATIONS-CCIS