NEC NEAX 2000 IPS - Page 297

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 283 – NWA-008853-001 Rev.3.0
97ch3004.fm
Operating Procedure
No manual operation is required.
DESCRIPTION DATA
Key No.
Data Description (Key Label) Default Data
13 F6000 C.O. Incoming Call 0 (LDN) NONE
14 F6040 Tie Line Incoming Call 0 (TIE) NONE
15 F6064 Call Forwarding-Busy Line (Busy) NONE
16 F6060 Operator Call (ATND) F6061 (Recall)
17 F6063 Call Forwarding-Don’t Answer F6060 (Operator Call)
(-No Answer) (NANS)
18 F6061 Recall (Recall) F6000 (C.O. Incoming 0)
90 F6200 Source (SRC) F6200 (Source)
91 F6201 Destination (DEST) F6201 (Destination)
93 F6203 Talk (Talk) NONE
94 F6204 Hold (Hold) F6204 (Hold)
95 F6202 Cancel (Cancel) F6202 (Cancel)
96 Answer (Answer)
97 Release (Release)
NOTE: When the DESKCON is used to set H/M features, the Reset key should be assigned to one
of the feature keys (i.e key 21) in the Idle state mode.
A
L6 (12)
L5 (11)
L4 (10)
L3 (09)
L2 (08)
L1 (07)
0
89
6
3
5
2
1
4
7
#
SRC
(90)
DEST
(91)
(93)
(95)
Answer
(96)
Hold
(94)
Release
(97)
Cancel
Talk
Position Busy
Volume
Night
(15)
(01) (02) (03)
(04)
(13) (16) (17) (18) (92) (19) (20) (21)(14)
(24)(22)
(23)
LDN TIE Busy ATND NANS Recall
EMG BV TRKSL Call Park SC SVC
REC
Mute
PAGE
Start
END
INCOMING CALL IDENTIFICATION-CCIS