NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 115
Call Hold - D
term
C-6D
C-6D Call Hold - D
term
General Description
This feature permits a D
term
station user to HOLD a call in progress by using CALL HOLD - D
term
.
Operating Procedure
To hold a call in progress without using the “HLD” key:
1. Press “XFR” key; receive Special Dial Tone. The LCD displays:
D
term
Series E
2. Dial the CALL HOLD [C-6] code; receive normal Dial Tone.
3. The call in progress is held; the user may initiate a new call.
To release a new call and return to the original call:
1. Go on-hook, releasing the new call; or press the “RCL” key.
2. The original call will ring back to the D
term
.
To hold a new call and return to the original call:
1. Press “XFR” key; receive Special Dial Tone.
2. Dial feature code; the new call is placed on HOLD, the original call is automatically returned.
Note:
By repeating the above steps, station user can converse alternately with two parties.
A feature/line key may be programmed as a “HLD” key:
1. While a call is in progress, press the “HLD” key.
2. The call is placed on HOLD, Dial Tone is restored.
3. A new call may be dialed.
4. To return to the original call, press the “RCL” key.
On a D
term
, a SPEED CALLING - ONE TOUCH [S-26] may be used to place a call on HOLD:
1. Press FNC, plus a SPEED CALLING - ONE TOUCH [S-26] key. The LCD will display any
previously stored data.
2. Press the “RCL” key. The LCD displays:
D
term
Series E
This acts as a switchhook flash. See FLASH ENTRY [F-4D].
XFR
(Time Display)
TRANSFER
(Time Display)
!
(Time Display)
!
(Time Display)
To Next Page
Loading...
