NEAX2400 ICS Business Features and Specifications
Page 534
NDA-24143, Issue 4
U-3 Universal Sender
U-3 Universal Sender
General Description
This feature permits dialed numbers to be transmitted via a sender, a device that will automatically add
or delete the necessary number of digits or perform any necessary conversions.
Operating Procedure
No manual operation is required.
Service Conditions
1. For incoming connections, digits may be deleted according to the route involved. A maximum of
4 digits may be added (inclusive of the access code).
2. For outgoing connections, digits may be added or deleted according to the route involved. A
maximum of 24 digits may be deleted, and a maximum of four may be added (inclusive of the
access code).
3. LEAST-COST ROUTING [L-5]: Digits may be added or deleted according to the route involved
and the dialed digits. A maximum of 24 digits may be deleted, and a maximum of 24 may be
added, consisting of either digits or 2.8 second pauses.
Interactions
1. For features requiring digit translation, refer to the specific feature programming description.
2. The ASTP, AOSP, and AISP commands operate to translate incoming TIE Line digits that are
received by the register and then sent to the opposite PBX via the UNIVERSAL SENDER. The
ANND command is used like the AMND command. It tells the system how many digits the
register is to expect for a specific route. The UNIVERSAL SENDER then sends the digits to the
opposite PBX.
Features requiring the UNIVERSAL SENDER are:
ATTENDANT CONSOLE [A-3]
ATTENDANT KEY PAD [A-4]
AUTOMATIC TRUNK TEST [A-21]
CALL FORWARDING-OUTSIDE [C-28]
LEAST-COST ROUTING-3/6 DIGIT [L-5]
OUTGOING TRUNK QUEUING [O-2]
OFF-HOOK QUEUING [O-7]
PUSHBUTTON CALLING [P-4]
PUSHBUTTON-TO-ROTARY CONVERSION [P-6]
SPEED CALLING-SYSTEM [S-3]
SPEED CALLING-STATION [S-21]
SPEED CALLING-GROUP [S-23]
TOLL RESTRICTION-3/6-DIGIT [T-7]
To Next Page
Loading...
