NEC NEAX 2400 ICS - Split Call Forwarding

NEAX2400 ICS Business Features and Specifications
Page 490
NDA-24143, Issue 4
S-99 Split Call Forwarding
S-99 Split Call Forwarding
General Description
This feature allows a station to set two different target stations for CALL FORWARDING-ALL CALLS
(FWD)/BUSY LINE (FWD-BY)/DON’T ANSWER (FWD-DA), depending on whether the incoming call is
from an internal station or an outside party (C.O. TIE, DID, etc.).
Operating Procedure
To operate:
1. Station A sets or is set for CALL FORWARDING-ALL CALLS/BUSY LINE/DON’T ANSWER.
Station B is set as the transfer destination for an incoming call from a station. Station C is set as
the transfer destination for an incoming call from an outside party.
2. An incoming call from a station terminates to Station A. The call is transferred to Station B.
(Note
1)
3. An incoming call from an outside party terminates to Station A.
(Note 2)
4. The call is transferred to Station C.
(Note 1)
Note 1:
For the transfer procedure, refer to the Operation Procedure of CALL FORWARDING-ALL CALLS [C-5],
CALL FORWARDING-BUSY LINE [C-2], or CALL FORWARDING-DON’T ANSWER [C-3].
Note 2:
The call may be transferred to Station B (transfer destination for an incoming call from a station), depending
on the route class data [ARTD, CDN 68:SCF] of the trunk involved.
To set SPLIT CALL FORWARDING using an access code:
To set Call Forwarding from an individual station (Single-line Telephone):
1. Setting Call Forwarding for an incoming call from a station:
a.) Lift the handset; receive Dial Tone.
b.) Dial the access code for FWD, FWD-BY, or FWD-DA for an incoming call from a station;
receive Special Dial Tone.
c.) Dial the number of the desired target station; receive Service Set Tone.
d.) Replace the handset.
2. Setting Call Forwarding for an incoming call from an outside party:
a.) Lift the handset; receive Dial Tone.
b.) Dial the access code for FWD, FWD-BY, or FWD-DA for an incoming call from an
outside party; receive Special Dial tone.
c.) Dial the number of the desired target station; receive Service Set Tone.
d.) Replace the handset.
To cancel Call Forwarding from an individual station (Single-line Telephone):
1. Cancelling Call Forwarding for an incoming call from a station:
a.) Lift the handset; receive Dial Tone.
b.) Dial the cancel code for FWD, FWD-BY, or FWD-DA for an incoming call from a station;
receive Special Set Dial Tone.
c.) Replace the handset.
2. Cancelling Call Forwarding for an incoming call from an outside party:
a.) Lift the handset; receive Dial Tone.
b.) Dial the cancel code for FWD, FWD-BY, or FWD-DA for an incoming call from an outside
party; receive Special Set Tone.
c.) Replace the handset.