NEC NEAX 2400 ICS - Speed Calling - Group

NEAX2400 ICS Business Features and Specifications
Page 476
NDA-24143, Issue 4
S-23 Speed Calling - Group
S-23 Speed Calling - Group
General Description
This feature allows a station user to share a set of common Speed Calling numbers with other station
users in the group.
Operating Procedure
To record:
1. Lift handset or press “SPKR” key; receive Dial Tone.
2. Dial the SPEED CALLING access code (one or two digits); receive Special Dial Tone.
3. Dial the abbreviated call code (one or two digits) and the called exchange network numbers;
receive Service Set Tone.
To operate:
1. Lift handset; receive Dial Tone.
2. Dial the SPEED CALLING feature access code.
3. Dial the abbreviated call code (one or two digits).
4. Call is completed.
To operate from a D
term
:
1. Press “LNR/SPD” key; receive Dial Tone. The LCD displays:
D
term
Series E
2. Press the desired call code; the call is completed.
Service Conditions
1. A maximum of 100 memory blocks per Module Group can be equipped for SPEED CALLING-
GROUP. A maximum of ten Speed Calling numbers per memory block can be assigned. This
allows for a total of 1000 numbers per Module Group.
2. A Master station will be assigned memory blocks, and associate stations in that group are
assigned as Slave stations. The Master station will have the capability to program 10 memory
blocks commonly used as Speed Calling numbers for that group; therefore, a group can consist
of 100 Speed Calling numbers maximum.
3. Each abbreviated call code can store a maximum of 24 digits, including access codes and
pauses.
4. A station can be assigned as a Master for only one group.
5. There is no limit to the number of Slave stations that may be assigned to one group.
(Time Display)
LNR [*] / SPEED [_ _]
(Time Display)
LNR [*] / SPEED [_ _]