NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 541
Volume Control - D
term
V-3D
V-3D Volume Control - D
term
General Description
This feature is used for controlling the volume of a D
term
set’s built-in speaker and receiver.
Operating Procedure
D
term
Series I and II Sets:
1. The D
term
set is equipped with a sliding volume control knob located in the front, beneath the dial
pad. Volume can be increased by moving the control to the right, and decreased by moving it to
the left.
2. The ringing volume is controlled by a switch on the underside of the D
term
. It is marked RING and
located directly below the LCD Display Panel. The ringing volume is increased by moving the
switch to the right and decreased by moving the switch to the left.
3. The ringing tone can be set to one of three distinct tones, using switch settings “1”, “2”, or “3”,
depending on user preference. Each switch setting produces a separate distinct ringing tone.
Setting “1” produces the lowest.
Setting “2” produces a medium.
Setting “3” produces the highest.
To control the ringing tone, there is a switch located underneath the D
term
. It is opposite the XFR key, and
is labeled RINGING TONE. It has switch settings marked 1, 2 and 3.
D
term
Series III and Series E Sets:
1. The D
term
is equipped with two control buttons located on the top front of the phone. Volume can
be increased by pushing the right control button while off-hook. Volume can be decreased by
pushing the left control button while off-hook.
2. The ringing volume is also adjusted by the same two control buttons. Ringing volume by pushing
the right control button while the D
term
is ringing. Decrease the ringing volume by pushing the left
control button while the D
term
is ringing.
3. The ringing tone can be set to one of four distinct ringing tones by performing the following: Press
FNC + 3. Each time this is performed, one of the four patterns is selected.
Service Conditions
Ringing, Recall Ringing, and Voice Call Signal Tone are not controlled by VOLUME CONTROL.
To Next Page
Loading...
