NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 327
Message Waiting Lamp Setting - Attendant M-23
M-23 Message Waiting Lamp Setting - Attendant
General Description
This feature permits an ATTENDANT CONSOLE [A-3] to set or cancel a Message Waiting indication on
a station provided with this feature.
Operating Procedure
To set a Message Waiting indication:
1. Press an idle loop key.
2. Dial the Message Waiting set code (up to 3 digits); receive Special Dial Tone.
3. Dial the station number; receive Service Set Tone.
4. Message Waiting indication is set.
5. Press the “RLS” key to return to an idle condition.
To cancel a Message Waiting indication:
1. Press an idle loop key.
2. Dial the Message Waiting cancel code (up to 3 digits); receive Special Dial Tone.
3. Dial the station number; receive Service Set Tone.
4. Message Waiting indication is cancelled.
5. Press the “RLS” key to return to an idle condition.
Service Conditions
1. The Message Waiting lamp on a single line telephone or a D
term
will be lit when this feature is
activated.
2. When Message Waiting is set to a 16-button or 24-button D
term
station, the LCD display
indicates:
D
term
Series E
3. Message Waiting cannot be set when the ATTENDANT CONSOLE [A-3] is in a consultation
condition with a station or trunk.
4. An Attendant attempting to set Message Waiting to a station where Message Waiting has
previously been set, will receive Busy Tone.
5. In a MULTIPLE CONSOLE OPERATION [M-4], if Message Waiting is set by one ATTENDANT
CONSOLE [A-3], it can be cancelled by another.
6. Message Waiting indications are cleared when the system is initialized.
(Time Display)
MW
MW
(Time Display)
To Next Page
Loading...
