NEC NEAX 2400 ICS - A-8 D Automatic Recall - D Term

NEAX2400 ICS Business Features and Specifications
Page 18
NDA-24143, Issue 4
A-8D Automatic Recall - D
term
A-8D Automatic Recall - D
term
General Description
This feature works as a timed reminder. When a D
term
handled call remains on hold (EXCLUSIVE HOLD
[E-4D] or NON-EXCLUSIVE HOLD [N-7D]) or during an unattended transfer for a variable, programmable
period of time, the D
term
is automatically alerted.
Operating Procedure
No manual operation is required.
Service Conditions
1. AUTOMATIC RECALL - D
term
timing is default in System Data at 30 seconds. See VARIABLE
TIMING PARAMETERS [V-1] for other selectable timing choices.
2. If the D
term
reenters a held or transferred call, timing is reset when the call is returned to a
RECALL position.
3. When a held call returns to the D
term
, a continuous ring of 0.5 seconds ON, 0.5 seconds OFF,
and an LED flashing at 240 IPM occurs until the call is retrieved. The upper LCD goes blank
during recall. The signal occurs whether the D
term
is on-hook or off-hook.
4. When an unattended transfer returns to the originator of the transfer, the D
term
will ring normally
for 30 seconds (VARIABLE TIMING PARAMETERS [V-1]), if the release signal is not provided
from the distant end. The LCD displays:
Transferred
Transferring
Station Station/Trunk
D
term
Series E
5. When a D
term
holds a call by NON-EXCLUSIVE HOLD [N-7D] during a THREE-WAY CALL
[T-2D], the AUTOMATIC RECALL - D
term
feature cannot be activated.
RCL XXXX
(Time Display)
XXXX
RECALL XXXX
XXXX
(Time Display)